The RMS application used to access, configure and
status the SC-3 and its components must be run on
the appropriate hardware for proper operation. The
table below lists both recommended and minimum requirements
for this hardware.
Item
Recommended
Minimum
Processor
Intel Pentium 266 MHz
Intel Pentium Processor
Operation System
Windows NT 4.0 - S.P. 3
Windows NT 4.0 - S.P. 3
Memory
128 MB Of Ram
64 MB Of Ram
Hard Disk
384 MB Free Space Including Swap
File
384 MB Free Space Including Swap
File
Monitor*
17" 1024x768 Color Monitor
17" 1024x768 Color Monitor
Video Card
1024x768 capable, 8 MB Ram
1024x768 capable, 4 MB Ram
CD-ROM
Any
Any
Ethernet Adapter**
10Base T
10Base T
Serial Port
Any
Any
Parallel Port
Any
Any
Mouse
Any
Any
3 ½ inch Floppy Drive
Any
Any
* The font size under the display
settings must be set to small fonts. The Arial font
set will be used by RMS and should generally be installed
via the standard installation of Windows NT.
** The Ethernet adapter is used
to connect to the SC-3 Controller for communications.
The SC-3 uses 10Base T for this communications link.
If your RMS PC will be connected to your LAN/WAN,
the adapter requirements may be different. See your
LAN/WAN administrator if this is the case.
